An individual heating point is an integral part of any industrial enterprise, providing for the technological needs of production. Also, ITPs are widely demanded in the civil sector, satisfying the needs of residents of multi-storey buildings in heating and hot water supply. For economical and correct operation in autonomous mode, this installation needs automated control and monitoring. The ITP automatic control panel is designed for continuous and automated operation of an individual heating unit. The task of this product is to regulate and control the parameters of the coolant of hot water supply and heating networks with minimal human participation. Algorithms of weather-dependent control and temperature control in the heated room rationalize the flow of the coolant, improving the efficiency of the installation. Also, our specialists have developed algorithms for technological protection of equipment from emergency situations and their negative consequences. To improve interaction with personnel, it is possible to install a visualization or dispatching system.
Advantages:
- Control of parameters of the heat carrier of heating and GVS.
- Weather-dependent temperature control.
- Software technological protection against emergency situations.
- Possibility to install a visualization or dispatching system.
- Warranty 12 months.
- Post-warranty service and support.
Individual heating point. OVERVIEW and operating principle:
On the front panel of the product there are manual controls and light indication, optionally a touch panel is installed. The product has 3 operating modes, which are set using a three-position switch, “Auto”, “Man” and “0”. Automatic mode provides for fully autonomous operation of the unit and maintenance of coolant parameters according to a weather-dependent schedule. The pressure is maintained by using a frequency converter, which is controlled by the PLC and allows you to change the operating modes of the pumps. Separately, it is possible to set the parameters of the coolant manually using the graphical screen of the controller or the interface of the operator panel. Manual mode is intended for manual control of circulation pumps by means of direct start in case of malfunctions with the frequency converter. If necessary, it is possible to interrupt the operation of the product by moving the three-position switch to the “0” position. In this mode, all units of the installation go into idle mode.
Characteristics
- The dimensions of the product are individual.
- The power of the product depends on the thermal power of the installation.
- Operating temperature +1…+50
